Tank Installation - ICON Level Pro ProScan Getting Started

Radar sensor
Table of Contents

Advertisement

ProScan
®

Tank Installation

Below are some considerations with respect to how the sensor can be installed on top of a tank. ProScan
out from the measurement transducer of the sensor. As a result, the height of the sensor above or below the top of the tank will affect the
dead band and 20mA settings.
Below are some examples of different tank configurations. The ProScan
band or dead zone. This is the area just below the tip of the sensor that consists of signal echo's that are returned too quickly
to differentiate the false signal from the measuring echo, therefore this space is not measured.
Special consideration is required during the installation to ensure the blanking area is taken into account.
The position of the sensor above or below the top of the tank will affect the blanking area and the 20mA setting.
Max Config
Range
Empty
Tall Riser,
Horn inside Riser
Programming Display
Measuring the tank is one of the most important aspects in configuring the sensor. When measuring the tank, take into account the
location of the sensor with respect to fittings, risers, dome tops and bottoms, and identify where the measurements are taken from the sensor.
The
The Range
Range is is the
the overall
overall distance
1.
from the
from
the Max
Max or or Full
Full Liquid
Liquid Level
the
the lowest
lowest liquid
liquid level
level | | Normally
would be when the tank is Empty
would be when the tank is Empty
Min Configuration = 4mA setting.
a)
b)
With flat bottom tanks, the Range
and Empty Configuration values can
be the same.
2.
Max Configuration = 20mA setting.
The distance from the tip of the
sensor to the highest liquid or full
level
Quick-Start
20 mA
Max Config
4 mA
Small Riser,
Horn within Tank
distance
Level to to
Normally this
this
5.25"
®
radar sensor has a blanking area also referred to as the dead
20 mA
Range
Empty
4 mA
Measurement
Location
100%
0%
®
has a dead band that extends
Max Config
Range
Empty
Directly on Top of Tank
20 mA
Max Config
Range
4 mA
20 mA
4 mA
04

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Level Pro ProScan and is the answer not in the manual?

Table of Contents