Intermec 751G User Manual page 69

VersionMin minor_version Numeric value returned by OSVERSIONINFO.dwVersionMinor. The .cab file is valid for
VersionMax major_version Numeric value returned by OSVERSIONINFO.dwVersionMajor. The .cab file is valid for
BuildMin build_number Numeric value returned by OSVERSIONINFO.dwBuildNumber. The .cab file is valid for
BuildMax build_number Numeric value returned by OSVERSIONINFO.dwBuildNumber. The .cab file is valid for
[CEDevice] ; A "template" for all platforms
UnsupportedPlatforms = pltfrm1; Does not support pltfrm1
; The following specifies version 1.0 devices only.
VersionMin = 1.0
VersionMax = 1.0
[CEDevice.ARM]; Inherits all [CEDevice] settings
; This will create a .CAB file specific to ARM devices.
ProcessorType = 2577; ARM .cab file is valid for ARM microprocessors.
UnsupportedPlatforms = ; pltfrm1 is still unsupported
; The following overrides the version settings so that no version checking is
performed.
VersionMin =
VersionMax =
[CEDevice.MIPS] ; Inherits all [CEDevice] settings
; This will create a .CAB file specific to "MIPS" devices.
ProcessorType = 4000; MIPS .CAB file is valid for MIPS microprocessor.
UnsupportedPlatforms =pltfrm2; pltfrm1, pltfrm2 unsupported for MIPs .CAB
file.
751G Color Mobile Computer User's Manual
Example
[CEDevice]
UnsupportedPlatforms = pltfrm1 ; pltfrm1 is unsupported
[CEDevice.SH3]
UnsupportedPlatforms = ; pltfrm1 is still unsupported
the currently connected device if the version of this device is greater than or equal to
VersionMin.
the currently connected device if the version of this device is less than or equal to
VersionMax.
the currently connected device if the version of this device is greater than or equal to
BuildMin.
the currently connected device if the version of this device is less than or equal to BuildMax.
Example
The following code example shows three [CEDevice] sections: one that
gives basic information for any CPU and two that are specific to the SH3
and the MIPS microprocessors.
Note: To create the two CPU-specific .cab files for the Setup.inf file in the
previous example, run the CAB Wizard with the "/cpu arm mips"
parameter.
Chapter 3 — Configuring the Computer
55