751G Color Mobile Computer User's Manual
Using Static WEP Security
The 751G uses the Wired Equivalent Privacy (WEP) protocol to add
security to your wireless network based on the 802.11b/g standard. To use
WEP security, you need an access point with an 802.11b/g radio.
Configuring Static WEP Security With Funk Security
Use this procedure to set Static WEP security with Funk security.
1 Make sure you have configured the communications and radio
parameters on your 751G and that Funk is your security choice.
2 Open Intermec Settings. Tap (+) to expand Communications > 802.11
Radio > Funk Security > Profile X with "X" being "1" through "4.".
3 For Association, select "Open" and press Enter.
4 For Encryption, select "WEP" and press Enter.
5 For 8021x, select "None" and press Enter.
7 For Transmit key, select which WEP key to use for encryption of
transmitted data.
8 Define a value for each key, up to four. Enter an ASCII key or a hex key
either 5 or 13 bytes long based on the radio capability. Set a 5-byte value
for 64-bit WEP or a 13-byte value for 128-bit WEP. Precede hex keys
with 0x and make sure the keys use 5 or 13 hex pairs.
Chapter 5 — Network Support
125