Table of Contents
Advertisement
• Depending on your device type and settings, location services may need to be
enabled to achieve connection.
• Make sure the app has registered successfully.
• Make sure your smart device is connected to the same WiFi network as that to
which you are attempting to connect the heater.
• Ensure you are connected to a 2.4G WiFi band. See instructions within the app if
you are currently connected to a 5G band.
• Check any local restrictions on your WiFi. WiFi networks in public places such as
hotels and airports may require extra identification steps.
7 | Using the App
NOTE – The Smart Life app is a constantly evolving third party system. The guide
below was correct at time of printing but may differ slightly from future versions.
7-1 | Home overview
You can use the Smart Life app to control multiple devices. All
devices are displayed on the home screen with their status.
Possible statuses:
• Online — Heater will respond to app commands.
• Offline — Device is turned off at wall or power switch. It
cannot be controlled by the app.
7-2 | Control interface
Tap the heater listing to go to the control interface, as
demonstrated in Figure 10 below.
Here you can turn the heater off and on, adjust set
temperatures, choose mode and access weekly programmer
and device settings.
7-3 | Choose mode
Tap the mode icon
choose mode.The four options correspond to the
five modes on the control panel.
7-3-1 | Comfort, eco & anti-freeze mode
In comfort and eco mode, simply use the sliding
dial or the – and + keys to adjust the set
temperature. The anti-freeze set temperature
cannot be adjusted.
Ecostrad_iQ_Plus_V2.6_15022022
on the control interface to
20
Advertisement
Table of Contents
