Troubleshooting; Power Supply - NEC SIGMABLADE N8406-017 Manual

Troubleshooting

This chapter provides general troubleshooting information for problems that might occur with
switch modules and pass-through cards.

Power supply

If the STATUS
• The power supply control unit, such as an uninterruptible power supply (UPS), is switched on.
• The power distribution board is switched on.
• The power cable is securely connected to the Blade Enclosure.
• The power cable of the Blade Enclosure is securely connected to a power-supply tap.
• The power supply tap is securely installed on the uninterruptible power supply (UPS).
• The power units are securely installed in the Blade Enclosure.
• The number of power supplies installed in the Blade Enclosure is sufficient.
• The redundancy mode of the power supplies in the Blade Enclosure is appropriate.
• The switch module/pass-through card is securely installed in the Blade Enclosure.
of a switch module/pass-through card is not lit green, check that:
LED
80