Table of Contents
Advertisement
4. Hold the both sides of the card with its
ejector side facing the top and slowly
insert the card halfway into the Blade
Enclosure (approximately 20 cm).
Important
Do not hold the ejector. Otherwise the
ejector might be distorted, damaging the
card.
5.
Insert the card slowly into the Blade Enclosure by pressing the frame of the card front with
your thumbs with the ejector fully opened.
Push the front side of the card carefully until it is inserted to the end of the Blade Enclosure and the
ejector closes slightly.
Hint
6. Close the ejector slowly.
The midplane connector of the card is connected to the midplane connector of the Blade
Enclosure.
If you cannot close the ejector successfully, check the stopper.
If you close the ejector while it is not correctly locked, the ejector or the Blade Enclosure may
be damaged.
(2)
(1)
59
Advertisement
Chapters
Table of Contents
