Charger Setup And Use, Charger With Touchscreen - ZOLL LifeVest 4000 Patient Manual

LifeVest 4000 Patient Manual

Charger setup and use, charger with touchscreen

WARNINGS
Use of accessories, transducers, and cables other than those specified or
provided by the manufacturer of this equipment could result in increased
electromagnetic emissions or decreased electromagnetic immunity of this
equipment and result in improper operation.
There are two types of chargers: One with a touchscreen, and one with indicator
lights. You will receive one or the other. If you have the charger with a
touchscreen, continue below. If you have the charger with the indicator lights,
see page 3-13.
Initial setup
Page 3-8
1 Place the charger in the room where you sleep, on a nightstand or
end table, near a power outlet.
 Place the charger so you can easily get to the top of the unit to
insert and remove the battery.
 The charger can be placed anywhere in the house, but we
recommend the room where you sleep so it's convenient to use
every day.
2 Plug the power supply into the back of the charger, then plug the
power supply into a power outlet. Make sure the outlet stays on all the
time and is not controlled by a light switch.
CAUTION: If the charger or power supply makes unusual
noises, sparking, starts to smoke, or emits a burning smell, unplug it
immediately from the wall outlet. The only way to completely remove
power is by unplugging the AC power plug from the wall outlet. Place
the charger so that the power plug is accessible in case you need to
unplug it.
Note: Use only the power supply provided with the LifeVest system.