Replace Belt - ZOLL LifeVest 4000 Patient Manual

LifeVest 4000 Patient Manual

Replace belt

To replace the electrode belt
1 Remove the battery from the monitor.
2 Disconnect the electrode belt from the monitor.
3 Remove the electrode belt and garment from your body.
4 Disassemble the electrode belt from the garment, assemble the new
electrode into a clean garment, and put on the assembled electrode belt and
garment. Refer to section 4.
5 Connect the electrode belt to the monitor.
6 Put the battery into the monitor and follow the normal startup routine.
Page 5-20
After you receive a treatment to correct an abnormal rhythm, you may
see this message telling you to replace the belt.
Continue to wear the belt until you get the replacement belt. The belt is
still functional and can provide additional treatment if needed.
When you receive the new belt, follow the instructions below to replace
the belt.
While you're wearing the LifeVest, tap the help button
about what to do.
Tap OK to resume normal monitoring.
for reminders