kingsley-bate CO-15 Assembly Instructions

ASSEMBLY INSTRUCTIONS FOR THE CO-15
RIGHT END FRAME
NOTE: During assembly of the furniture please match all joints with the corresponding
letters or numbers stamped on the furniture.
dowels into the pre-drilled holes of the assembly, details are shown in the photographs. All
dowels and dowel holes are properly marked with stickers. NOTE: DO NOT FORCE THE
DOWELS; ANY EXCESS CAN EASILY BE SANDED AWAY. IF THE DOWELS
ARE NOT FLUSH DO NOT CONTINUE TO DRIVE THE DOWELS, YOU MIGHT
DAMAGE THE ITEM.
KINGSLEY~BATE
Fine Garden Furniture
BACK
* NOTE:
A TENON
B MORTISE HOLE

STEP-I

Unpack, inspect and lay the parts on a clean, flat, soft
surface to avoid marring the wood.

STEP-II

Fit the BACK and SEAT tenons into the END FRAME
mortise holes using the stamped numbers or letters as
guides. If necessary, gently rock the BACK and SEAT
while pushing the tenons into the mortise holes until all
joints fit snugly together.
SEAT

STEP-III

Fit the remaining END FRAME mortise
holes over and onto all exposed tenons
and using a rubber mallet gently tap the
END FRAME evenly until all joints fit
snugly together. Carefully hammer
LEFT END FRAME