Advertisement

LIFT OUT TRAY
DRAWER FRAME
WHEELS

STEP-I

Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match all joints with the corresponding
letters or numbers stamped on the furniture.
DRAWER FRAME, BOTTLE RACK carefully line up all parts. Using a rubber mallet,
evenly drive all the tenons into the mortise holes as shown in the assembly photos.
KINGSLEY~BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE SC-25
DRAWERS
END FRAME WITH WING
TOP FRAME

STEP-II

Find the END FRAME W/O WING (should be the
one with numbers stamped on it). Lay this END
FRAME down first. Matching the numbers on the
END FRAME with those on the TOP FRAME,
BOTTOM
FRAME,
BOTTOM FRAME
END FRAME W/O WING
* NOTE
A TENON
B MORTISE HOLE
HANDLE
BARS
and

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SC-25 and is the answer not in the manual?

Questions and answers

Summary of Contents for kingsley-bate SC-25

  • Page 1 KINGSLEY~BATE Fine Garden Furniture ASSEMBLY INSTRUCTIONS FOR THE SC-25 LIFT OUT TRAY DRAWERS TOP FRAME BOTTOM FRAME DRAWER FRAME END FRAME WITH WING END FRAME W/O WING * NOTE A TENON B MORTISE HOLE WHEELS STEP-I Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
  • Page 2 STEP-III Carefully place & align the END FRAME WITH WING onto the assembled TOP FRAME, BOTTOM FRAME, HANDLE BARS, BOTTLE RACK and DRAWER FRAME. The TOP FRAME has an extension arm with a leather pull attached to it. Please make sure that the leather pull is aligned properly with the routed hole in the END FRAME WITH WING.
  • Page 3 Slide the drawers into place as shown in the diagram. IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR CHOOSING OUR FURNITURE. * KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE...

Table of Contents