Table of Contents
Advertisement
6.3.4 Interface Specifications (GT02L)
Interface for connecting PLC/External devices
- COM port
Item
Communication standard
Communication
Baud rate (bit/s)
condition with
Data length (bit)
external
Parity
devices
Stop bit (bit)
Transmission distance
(Total length)
Terminal resistance value
Protocol
Connector
Note1) The (+) and (-) terminals are the power supply terminals for driving the main unit.
Note2) Regarding power supply voltage, please pay due consideration to the cable length so that the
applied voltage is within the operation voltage range.
Note3) When tightening the terminal block requires a flat-blade screwdriver with a blade size of 0.4 x 2.5
or special screwdriver (part No.: AFP0806). Set the tightening torque between 0.22 Nm to 0.25
Nm.
Applicable wire
Interface for transferring screen data
- USB port
Item
Communication standard
Note1)
Connector shape
Trasmission distance
No. of connected unit with PC 1 unit
Note1) Take care of handling of the connector not to add an excessive static electricity on the metal part
of the connector.
RS232C type
Conforms to RS232C
(Non insulation type)
9600, 19200, 38400, 57600, 115200 bps
7, 8
None, Odd, Even
1
Max. 15 m
(Baud rate: 19200 bit/s)
－
MEWTOCOL (Protocol for PANASONIC PLC: FP series)
-
MEWTOCOL7 (Protocol for PANASONIC PLC: FP7 series)
-
General-purpose serial (PANASONIC dedicated protocol)
-
Protocol for other companies' PLCs
-
(For the details, refer to the latest GTWIN HELP.)
Connector terminal base (8-pin)
Size
AWG#28 to 16
USB1.1
USB MiniB type 5pin (Male)
Max. 5 m
Specifications
RS422/RS485 type
Conforms to RS422
(Non insulation type)
Max. 500 m
(Baud rate: 115200 bit/s)
120
Note1) 2) 3)
Nominal cross-sectional area
2
0.08 to 1.25mm
Specifications
6-13
Advertisement
Table of Contents
