Panasonic GT32-R User Manual page 140

For GT02, GT02L, GT03-E, GT05, GT12, GT32, GT32-R and GT32-E
Code No. Content
Cannot be executed
due to operation mode.
(The PLC received the
ER0001
command that cannot
be executed in the
operation mode.)
Data error
ER0010 A data error occurred
during communication
Overrun error
ER0012 The GT cannot receive
data.
Numerical data error
ER0015 Designated read/write
area is wrong.
 Error codes other than these are based on Omron PLC error codes.
 Be sure to used the PLC in monitor mode. Otherwise, communication will not work properly.
 When Connected to a PLC Made by Toshiba Machine Co., Ltd.
For GT02, GT02L, GT03-E, GT05, GT12, GT32, GT32-R and GT32-E
Code No. Content
ERFFFE Parameter error
5-18
Cause and solution
Change the mode of the PLC from the operation mode to the
monitor mode.
Check for errors in the communication conditions settings.
PLC runaway might be the problem.
Verify whether or not the reference device used with the basic
communication area and each part is a readable and writable
area.
Cause and solution
The specified parameter does not exist, or it cannot be used.