Connecting To Screen Creation Tool Gtwin; Tool Port; Usb Port - Panasonic GT32-R User Manual

2.3 Connecting to Screen Creation Tool GTWIN

2.3.1 TOOL Port

Note:
 The +5V of Pin 5 is reserved for the FP Programmer II. It should not be used for any other application.
If using it, there is a restriction on the ambient temperature. The pin 5 of GT01 is N.C.

2.3.2 USB Port

USB connection
Communication with our software such as GTWIN becomes available by connecting to a PC with a USB
cable.
Functions enabled by USB connection
 Through function using our PLCs
 Screen transfer
Note: If more than one programmable display unit or AE20 are connected to a PC using the USB
port, the communication is not available.
2-18
Pin No. Name
1 Signal ground
2 Send data
3 Receive data
4 Not connected
5 +5 V
Abbre. Signal direction
SG
SD GT→External device
RD GT←External device
N.C.
(+5V)
-
-
-