Table of Contents
Advertisement
6. WALL MOUNT INSTALLATION (OPTIONAL)
a.
Optional WS38DC (duct cover) is required for wall mount installation.
b.
Make sure all preparation steps are completed.
c.
Determine your ceiling height prior to installation.
d.
Be sure you have theWS38DCand the following contents.
e.
Determine the exact location you want to install the range hood.
f.
Adjust the wall hinges on both side of the unit and mount directly onto the
wall.(Fig. 5a)
g.
Use a spirit level to ensure the balance of the hood is true.
h.
Center the first duct cover bracket right above the unit. (Fig. 5b)
i.
Center the second duct cover bracket at your desired height. (Fig. 5c)
NOTE: IF USING CFM reducer, connect the reducer to unit
before continuing.
j.
Connect 6" ducting to the collar of the unit and secure it with aluminum
tape. (Fig. 5d)
k.
Insert duct cover at the back center of the hood. (Fig. 5e)
l.
Locate the bottom screw hole on both sides of the duct cover. (Fig. 5f)
m. Insert duct cover screws on both sides of the duct cover.
n.
Adjust the duct cover to the desired height and slide it into the duct cover
mounting panel and bracket. (Fig. 5g)
o.
Secure it the top duct cover with the duct cover screws. (Fig. 5h)
Installation diagram available on next page
i. Hood unit height = 8-1/4""
ii. Duct cover minimumheight = 19-1/2"
iii. Duct cover maximum height = 38"
Advertisement
Table of Contents
