Setting Up Your Network; Before You Begin - Intermatic HA07 Setup And User Manual

8
HomeSettings HA07 Wireless Master Controller

Setting up your network

Setting up your network Setting up your network

Before you begin...

Creating your network means to assign or
"include" individual HomeSettings modules to the
HA07 Master Controller. Modules must be assigned
to the master controller before any programming or
remote control functions can be accomplished.
Before setting up your network or programming the
buttons on the HA07 Master Controller, make sure
you do the following:
• Plug in or hard wire the individual HomeSettings
modules in the permanent location where you
will be using them.
• Plug devices (for example, lamps) into the
modules during network setup and the
programming of control buttons.
• Make sure these devices (lamps) are turned ON.
For best results, do not move or relocate modules
after they have been included into the network.
If you wish to re-locate or move a module from a
particular location, first delete it from the network,
then include it back to the network after you have
re-located it.
NOTE: HA06, HA14 and HA20 Dimmer Switches
have a 40-Watt minimum lamp requirement.
NOTE: Compact fluorescent bulbs should not be
used with dimming modules such as HA03, HA05,
HA06, HA14, and HA20.
Copyright © 2007 Intermatic, Inc.