Do you have a question about the P1353ME and is the answer not in the manual?
Questions and answers
randy merkord
April 20, 2025
how do you set the pool light
1 comments:
Mr. Anderson
May 10, 2025
To set the Intermatic P1353ME pool light:
1. Press the "Program" button to select a load (e.g., Load One). 2. Use the up/down arrows to set the start time for the light, then press "Enter." 3. Set the stop time, then press "Enter." 4. To avoid conflicts, only set one event per load. Do not set events in Event Two or Three. 5. For other loads (e.g., Load Two for low speed), set the start time about one minute after the high-speed load ends. 6. Typical runtimes are: - High speed: 2–4 hours (summer) - Low speed: 7+ hours (summer) - Cleaner: 1–2 hours
Use the controls to adjust times based on your pool needs.
INSTRUCTION MANUAL INTERMATIC MULTIPURPOSE CONTROL MECHANISM MODEL: P1353ME ATTENTION...
Page 5
ROUTE ACCESSORY WIRES AND INSTALLING THE SHUTTER BUSHING CONNECTORS INTO ENCLOSURE AND CONNECT TO THEIR PROPER LOCATIONS...
Page 6
CUT & INSTALL TUBING OVER THE LOW SNAP THE MULTIPURPOSE CONTROL VOLTAGE ACCESSORY WIRES AND/OR CORDS INTO THE INTERMATIC PANEL...
Page 7
C C H H O O O O S S E E M M O O D D E E 1 1 T T O O C C O O N N T T R R O O L L N N Y Y T T H H R R E E E E I I N N D D E E P P E E N N D D E E N N T T C C I I R R C C U U I I T T C C H H O O O O S S E E M M O O D D E E 2 2 T T O O C C O O N N T T R R O O L L T T W W O O S S P P E E E E D D P P U U M M P P N N D D O O N N E E I I N N D D E E P P E E N N D D E E N N T T C C I I R R C C U U I I T T C C H H O O O O S S E E M M O O D D E E 3 3 T T O O C C O O N N T T R R O O L L...
Page 9
MULTIPURPOSE CONTROL RATINGS, WIRING AND SETTING THE MODE Control Ratings and Individual Circuit Ratings...
Need help?
Do you have a question about the P1353ME and is the answer not in the manual?
Questions and answers
how do you set the pool light
To set the Intermatic P1353ME pool light:
1. Press the "Program" button to select a load (e.g., Load One).
2. Use the up/down arrows to set the start time for the light, then press "Enter."
3. Set the stop time, then press "Enter."
4. To avoid conflicts, only set one event per load. Do not set events in Event Two or Three.
5. For other loads (e.g., Load Two for low speed), set the start time about one minute after the high-speed load ends.
6. Typical runtimes are:
- High speed: 2–4 hours (summer)
- Low speed: 7+ hours (summer)
- Cleaner: 1–2 hours
Use the controls to adjust times based on your pool needs.
This answer is automatically generated