Creating A Network; Include Modules To A Network - Intermatic HA07 Instructions Manual

Setting Astronomic Function (continued)
Fig 7 – SUNSET default time may be different than shown
above. Press ENTER to accept the default time.
NOTE: Creating a network refers to assigning modules to the
master controller. All modules must be assigned to the master
controller before any programming or remote control functions
can be accomplished.
NOTE: Devices should be plugged into modules before adding
modules to the network. Devices (for example, lamps) should
be turned to the ON position.
1. (See Fig 8a) Press and release the INCLUDE button.
The INCL icon and TRANSMITTING message will
begin to flash, indicating that the controller is ready to
include modules to the system. (If INCL and
TRANSMITTING stop flashing, the controller has "timed
out". The INCLUDE button must be pressed again).
Page 14 of 35

Creating a Network

INCLUDE Modules to a Network