Programming The Code - mr. steam Tempo/Plus Control Owner's Manual

The TEMPO/REMOTE
installed. If these batteries have been removed for more than 3 minutes or
are discharged then the TEMPO/REMOTE
1• Press SETUP key.
4• Enter the 5-digit Code
No. 11433.
TEMPO / TEMPO/PLUS / TEMPO/REMOTE
® ®
control is supplied with two AAA batteries already
®
2• Press and hold PROG 1
key. The indicator will
flash.
5• The indicator will shut off
if the code is correct and
the setting was success-
ful. If not, the indicator
will flash twice. Check
the code and repeat the
programming process if
necessary.
/ TEMPO/EXT • Owner's Manual
® ®

Programming the Code

code must be re-entered.
®
3• While holding PROG 1
key, press CODE key for
two seconds until the
indicator lights up. Then
release both keys.
Note: The remote control
will exit programming mode
if any other keys but the
numerical ones (1, 2, 3, 4)
are pressed.
Note: Delays longer than
10 seconds between key
presses automatically cancels
programming mode.
15