Wireless control with smart home interface (4 pages)
Summary of Contents for mr. steam iSteam 3 Control
Page 1
Installation, Operation & Maintenance Manual Installation, Operation and Maintenance Manual iSteam 3 Control ® Linear Steam Head Residential Model: 104480 ____________________ teri steam Feel Good Inc. ® steam ® ® Feel Good Inc. ®...
® When installing and using this electrical equipment, basic safety precautions should always be followed, including the following: R E A D M E F I R S T ! IMPORTANT SAFETY INSTRUCTIONS As you follow these READ AND FOLLOW ALL INSTRUCTIONS instruc-tions, you will notice warning and caution symbols.
® Table of Contents: Box Contents: Important Safety Instructions ....1 • iSteam®3 Control • Control Cable (30 ft.) I N S T A L L E R I N F O R M A T I O N •...
Do not alter or modify with the MrSteam control’s intended use and function. any Mr. Steam products including the steam generator or iSteam3 control. Doing so may result in an inopera- tive or hazardous installation and will void the warranty.
INSTALLER INFORMATION ® Locating the Control ® Determine the desired installation location of the control. The iSteam controls are designed to be installed inside or outside the steam room as a matter of personal preference. If the control is installed inside the steam room: location representative of the desired steam bathing temperatures.
INSTALLER INFORMATION ® Installation with Optional Rough-In Box (cont.) IMPORTANT NOTE: Be careful not to strain, staple, pinch or otherwise damage the cables. Route cables as required to permit replacement. Do not route cables inside conduit together with power lines or close to hot water or steam piping. STEP 6 Use the rough-in box as a guide to cut out the Rough-In box used as...
INSTALLER INFORMATION ® Installation Instructions for iSteam ® STEP 1 PLUG the 30’ control cable into the iSteam3 control pigtail (1a). Turn the generator on and test the control to verify correct connection. With proper function, proceed to Step 2. Do not force or twist cable ends together.
Page 8
INSTALLER INFORMATION ® Installation Instructions for iSteam ® (cont.) STEP 2 Peel the double stick adhesive off the back of the iSteam3 control (2a). Apply a bead of silicone around the rear of the iSteam3 control to create a moisture seal (2b).
Page 9
® H O M E O W N E R S E C T I O N When installing and using this electrical equipment, basic safety precautions R E A D M E F I R S T ! should always be followed, including the following: As you follow these As you follow these instruc- IMPORTANT SAFETY INSTRUCTIONS...
USER/HOMEOWNER INFORMATION ® Press to save the current settings. A keyboard will open for the user to enter their name. A maximum of 8 user can be saved.
USER/HOMEOWNER INFORMATION ® Care Tips Use only mild soap and water on a soft cloth to clean the control. Do not use abrasive cleansers. Safety and Operating Information A peel and stick warning sticker is provided WARNING in the MrSteam steam generator Installation, Operation and Maintenance Manual.
Page 16
steam ® Feel Good Inc. ® www.mrsteam.com Products, information and specifications are subject to change without notice. Please call Technical Support at 1.800.76.STEAM (East Coast) or 1.800.72.STEAM (West Coast) for more information. The model and serial number is printed on the data plate on the front of the steam bath generator. Have this information available when contacting Technical Service.
Need help?
Do you have a question about the iSteam 3 Control and is the answer not in the manual?
Questions and answers