Table of Contents
Advertisement
Function
Advanced
Auto Input
Setting
Detection
Input
*1
Skip
On-Screen
Logo
SDI 1 Input
equalizer
RS-232C
Monitor Reset
*1 Disabled during dual screen display (PbyP or PinP).
12
Chapter 2 Advanced Adjustment / Setting
Setting
On / Off
*1
DisplayPort - / Skip
HDMI
SDI 1
SDI 2
DVI
On / Off
On / Off
19200 bps / 115200 bps
OK / Cancel
Description
This function automatically recognizes the
connector through which computer signals
are input, and displays images on the screen
accordingly.
• "On"
When the monitor is connected to
multiple devices, if a specific device
enters power saving mode or no signals
are input to the monitor, the connector is
automatically changed to another one to
which signals are input.
• "Off"
Set to this when manually selecting input
signals. In this case, you can select
the input signal to display using the
control button on the bottom of the
monitor. For details, see
Input Signals" (page
5).
Note
• When this function is set to "On", the
monitor only enters the power saving mode
when signals are not input from any device.
When "Auto Input Detection" is "On", select
the port to skip signal detection.
Note
• If all of the ports are set to "Skip", then
input signal will not be detected, in the
same way as when "Auto Input Detection"
is set to "Off".
Select whether to display or hide the logo
when the monitor starts.
Corrects the SDI 1 input signal
Note
• If noise is apparent when using the short
SDI cable, set this to "Off".
Sets the communication speed when
controlling this product from an external device
connected using the RS-232C terminal.
Restores all settings to their default values.
"1-2. Switching
Advertisement
Table of Contents
