Intellinet 523295 User Manual page 30

Idle Time Out
Enable
IP Address
Port
Click <Apply> at the bottom of the screen to save the above configurations. You can now
configure other advance sections or start using the router (with the advance settings in place)
Enter the Max Idle Time (in minutes) allowed after login to the
web configuration. If you idle long then this time, the router will
force to close the login session and you have to login again if
you want to continue doing further configuration. If you assign "0"
for this value, there will be no time out.
Check "Enable" to enable the remote management function.
This is the IP address of the
management/configuration access to the Broadband router from
a remote site. This means if you are at home and your home IP
address has been designated the Remote Management host IP
address for this router (located in your company office), then you
are able to configure this router from your home. If the IP
Address is left 0.0.0.0 this means anyone can access the
router's web-based configuration from a remote location,
providing they know the password.
Click the Enable box to enable the Remote Management
function.
Note: When you want to access the web-based management
from a remote site, you must enter the router's WAN IP address
(e.g. 10.0.0.1) into your web-browser followed by port number
8080, e.g. 10.0.0.1:8080 (see below). You'll also need to know
the password set in the Password Setting screen in order to
access the router's web-based management.
The port number of remote management web interface.
30
host in the Internet that will have