Receiver; Receiver's Switches Description - ENGO CONTROLS E901RF Full Manual

3. Receiver

The thermostat communicates wirelessly with the receiver. The receiver should be supplied with 230VAC, the maximum switching load of the receiver is
16A. Avoid installing the device in places directly exposed to water, moisture and air condensation. The receiver can operate in two different modes - AUTO
(automatic) and MANUAL (manual). To select a specific mode, use the switches on the front of the receiver.

3.1 Receiver's switches description

1
REMEMBER!:
Thermostat (transmitter) will communicate with receiver only when both are paired together and receiver's switches are set to ON and AUTO position.
8
E901RF FULL USER MANUAL
2 3 4
LEFT SWITCH
1. ON - receiver ON
2. OFF - receiver OFF
RIGHT SWITCH
MANUAL - Receiver works in manual mode
3. (receiver operation state depends on the position of
the left switch)
AUTO - Receiver works in AUTO mode
4.
(according to the thermostat's commands)