Special Parameters; Accessing The Special Parameters; Twisting Correction - Katanax K2 Prime Manual

Automatic fluxer
Table of Contents

Advertisement

This section presents an advanced interface window that can be used to adjust
the offset sensitivities of various electro-mechanical sensors on the fluxer.
Accessing the
Special
parameters
To invoke the Special parameters window, Press on the padlock icon at bottom
right of the main screen and enter the following code "2206" followed by ENT key.
The following window appears:
Twisting
correction
The top section enables (default) or disables, and adjusts the automatic twisting
correction. At the end of each fusion, the crucible holder automatically rocks
backwards to an angle larger than those allowed in fusion parameters. This
movement causes each side of the holder to bump against a mechanical stopper,
while the stepper motors slip magnetically. This readjusts both sides of the holder
in the same plane, therefore effectively cancelling any twisting of the holder.

Special parameters

WARNING: Changing these parameters should only be done by trained
personnel. Incorrectly setting these parameters could cause damage to the
instrument.
47

Advertisement

Table of Contents
loading

Table of Contents