Prepare Components - Spacerails Level 2 Instruction Booklet

1

PREPARE COMPONENTS

A
ARM A
(QTY: 17)
Step 1: Attach one Arm Holder A and one
Arm Holder B with one Arm Sheath. Insert
one Arm Clip into Arm Holder A.
To avoid damaging parts, do not move or adjust the Rail Clip while locked in the arm. To move the Rail Clip,
release Arm Lock by turning clockwise, position Rail Clip as desired, then secure Arm Lock again.
B
SEE-SAW ARM
Attach Arm Holder B to the square receiver side of Arm Sheath to
create the arm. Attach the arm to the shaft and the shaft to the
base prior to attaching the round receiver side of the Arm Sheath
to the See-Saw Arm.
Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com
(QTY: 1 LEFT & 2 RIGHT)
Cut two 55 mm lengths of rail
and insert into See-Saw Arm
as shown using a Rail Clip to
support the ends of the rail.
Step 2: Insert Arm Lock through
Arm Holder A and Arm Clip.
Step 3: Turn the Arm Lock
counter-clockwise to secure
the Arm Clip in place.
Page 3