Fisher & Paykel RS80A1 Installation Manual page 35

Adjust the Custom steel door panels
Door panel
attachment kit
8x16 mush washer screw
(2)
Tools
Hex key
1
#8 x 16
Mush Washer
Twin Thread
Philips Screw
FPA spanner
Cross-head screwdriver
Powered driver (optional)
Ruler
2
DOOR PANEL INSTALLATION — CUSTOM
Push the appliance into the
cavity until the door panels are
flush with adjacent cabinetry
surface.
Place a ruler on the front of the
appliance to check flushness
top and bottom, left and right..
B
A
To adjust the height of the panel, turn the
stud clockwise to raise or counter-clockwise
to lower the door panel.
Each door panel has full axis adjustment
z
to ensure flushness with adjacent walls.
Once satisfied with the alignment, secure M8
studs with M8 washer and M8 nut (B).
The top of the stud must remain below
z
the top face of the door panel.
Secure side bracket forks by tightening side
screws. Repeat for all door panels.
For depth adjustment, loosen the side
z
screws, adjust the panels and then
retighten once satisfied.
3
Further adjustment of door panels can be
z
achieved by removing door panels then
loosening the fixing screws for the hanging
bracket and moving the bracket sideways
to suit.
Loosen the M8x16 crosshead screw so that
locking bracket can slide freely back to front.
Slide the locking bracket out until it touches
4
the back of the door panel. Fully tighten the
screw.
Screw in place using #8x16 screw through
one of the three slotted holes.
35