Fisher & Paykel RS80A1 Installation Manual page 14

Dimensions apply for the preparation and installation of custom door panels.
For Dwg and Dxf files of the below panel preparation download the folder on thekitchentools.fisherpaykel.com.
29.1mm
87.2mm
Cut outs are located in attachment bracket for Fisher & Paykel handles only.
If locating custom handle in the shaded area above, ensure handle screw heads
are counter sunk into back of panel to avoid interference with hanging bracket.
14
CUSTOM DOOR PANEL INSTALLATION DIMENSIONS — RS90
385mm
Ø 2mm REF
10x Pilot holes recommended
for bracket attachment.
128mm
(Do not penetrate front surface).
All measurements to be made
from top and centerline.
416mm
DRAWER PANEL — REAR VIEW
Recommended hole locations for installing Fisher & Paykel design handle.
124.5mm
Ø 6mm REF
4x Through holes
recommended for
handle attachment.
DRAWER PANEL — REAR VIEW
30.3mm