Fisher & Paykel RS80A1 Installation Manual page 28

Attach the Stainless steel door panels
Tools
Cross-head screwdriver
Powered driver (optional)
1
Hex key
FPA spanner
28
DOOR PANEL INSTALLATION — STAINLESS STEEL
Open the door and loosen the M5x10
cross-head screws (do not remove) at
the sides of the doors
Hang the door panel by lowering the
holes of the hanging bracket onto the
M8 studs.
3
2
Loosely screw the M8 washer and nut to
the stud using the hex key and spanner.
This will allow opening the door
z
without affecting adjustment of the
door panel.
Slide the forks of the side brackets
onto the screws of the door.
Tighten the screws loosely to
temporarily secure the door panel.