Fisher & Paykel RS80A1 Installation Manual page 27

Ice and Water display Failure to follow these steps can lead to difficulties in door panel adjustment and cosmetic cap fitment.
●
(Ice and Water models Remove the protective film from the appliance doors before hanging door panels.
●
only)
Connect external display module (for Water dispensing model only)
External display module
(1x)
1
2
DOOR PANEL INSTALLATION — STAINLESS STEEL
Locate the external display
module from inside the
appliance.
Thread the display harness
through the door panel cavity.
Ensure the grommet is
z
engaged.
Turn the top display tabs at an
angle into the door panel.
Ensure the harness is free
z
of pinching.
Push firmly against the bottom
display tabs and insert into
the door panel until you feel
it clip securely.
Ensure the display is flush
z
with the door panel.
Remove water tube from the
holder on the appliance door.
Hang the door panel onto M8
studs.
Ensure the panel is free to pivot
for water connections.
D
3
4
5
Connect the display harness
onto the appliance door by
inserting firmly until you feel it
clip securely.
On the external display, activate
the dispenser lock to prevent
any water from dispensing
during water connection.
To lock, press the button for
4 seconds.
The LED above the button will
illuminate.
Enable the dispenser lock
to prevent any water from
dispensing during water
connection.
To lock, press the button for
4 seconds. The LED above the
button will illuminate.
Push the water tube firmly into
the spigot behind the door
panel until the marked line is
not visible.
Ensure the water tube is
z
routed away from any sharp
objects or corners, and not
in a location where it can be
kinked or squashed when
the door panel is secured,
(as this will stop water flow).
27