Page 2
Start from the rear lights, remove the rear lights, detach the red tiles...
Page 3
Combine the red tiles with the lighting parts Restore the lights, hide the wires underneath the car...
Page 4
Move the connector to the bottom and stable by the 1x2 plates provided Then for the front lights, remove the clear orange tiles to combine with the lights...
Page 5
Restore the orange light on any side first Restore one side of the front light and move the remain lights to other side by passing through the engine area...
Page 6
Then restore the other light Pass the connector to the bottom of the car by the hole shown...
Page 7
At last assemble the remain lights Remove the top, assemble the lighting plate with the longest wire...
Page 8
Put the top back, pass the remain lights to the back and assemble as shown...
Page 9
Pass the connector to the bottom through the shown gap Stable the connectors by the 1x2 plates provided...
Page 10
Now you can choose to power by USB or battery. If powered by battery, connect to the battery case and stick it underneath the vehicle If powered by USB, connect the connectors to the USB cable...
Need help?
Do you have a question about the Lego Pickup Truck 10290 and is the answer not in the manual?
Questions and answers