Page 2
For the rear part of the car, remove the brake light and the pipes, leave the following parts and prepare this lighting parts...
Page 3
Install the lighting brake lights and pull the wire through to bottom Assemble the lighting parts into the pipe...
Page 4
Put the pipes back to the position and beware of the wires when assembling Leave the connectors and deal with that later Prepare following lighting parts for the middle of the car...
Page 5
Install the 1x4 lighting plate at the following position and pull the connector to bottom Now remove the following part to assemble with this lighting part...
Page 6
Remove 3 grey round parts and push the leds into the red hole (Be sure it’s deep enough) Then restore the parts...
Page 7
Now for the front, remove the grey barrier and the trans orange tile to combine with the lights Remove the round plates from the headlights, assemble with the lighting parts And please follow the layout of the lights,...
Page 8
Install orange light on right side, connect the extend cable and connect each other...
Page 9
Then install the head lights Now you can make it look better by hiding the cables, for separate the connector from last step, pass one side of it behind the bumper and reconnect it...
Page 10
The other connector can be hidden in here Restore the grey barrier then the assembling is finished...
Page 11
To power up by USB, arrange all the connectors to the bottom of the car as shown...
Page 12
To connect by battery case, pull all the plugs to the co-pilot seat position Find out the connector for the lights in red circle and connect with the separate battery case and connect the rest 5 connectors with the big battery case...
Page 13
After that hide the cases to the position as shown...
Need help?
Do you have a question about the Lego Technic Fast & Furious Dom's Dodge 42111 and is the answer not in the manual?
Questions and answers