Related Manuals for Glow Bricks Gingerbread House Lego 10267
Summary of Contents for Glow Bricks Gingerbread House Lego 10267
- Page 2 Before installing the x’mas tree lights, break up the tree first Install the lights as shown, replace the lighting round plates to the tree (trans-orange replace the gold round plate)
- Page 3 Put the green plates with lights on, adjust the wires then put the remain green plates Then put the remain lighting round plates on then the tree is done...
- Page 4 Start with taking the front door out as shown Then assemble the lamps of the front door with the lighting black round plates Then install the lamps and the 1x4 light as shown...
- Page 5 Put the door back and beware the wire has to be in between the studs or it will be broken Before assembling the flames to the fireplace, take the following parts away Assemble the flames...
- Page 6 Then restore the outer side of the fireplace first To restore the fence, first we insert as shown then push it upward...
- Page 7 After restoring the fireplace, install the candles and ceiling lights as shown Then put the sofa back...
- Page 8 Pull the connector out as shown and leave it To pull the remain lighting parts to the 2nd floor, remove the parts as shown first...
- Page 9 Pull the lighting parts to 2nd floor, to make it looks nicer you can hide cable as shown Then install the 1x6 lighting part...
- Page 10 Then remove this part in purpose to let the wires go through The 1x2 lighting part is installed in the red circle area...
- Page 11 Pull the remain lighting parts over and replace the lamp parts Then install the lamp and the lighting plates...
- Page 12 Restore the part back then we can go to the next step Take the white plates away...
- Page 13 The long lighting plate is installed as shown...
- Page 14 Before install the lighting parts, you can take the smoke pipe the these white parts away first to make it looks better and easier to connect to the other side Now you can install the remain light...
- Page 15 Install the lights then connect the wires The connectors can be hidden as shown, then put the smoke pipe back...
- Page 16 Remove the parts and white plates as shown to install the lights...
- Page 17 Hide the wire to make it looks better the put the roof back Then connect all the connectors to the USB cable and light them up...
Need help?
Do you have a question about the Gingerbread House Lego 10267 and is the answer not in the manual?
Questions and answers