Summary of Contents for Glow Bricks FRIENDS Lego 21319
Page 2
First take off the right spot light, remove the clear 2x2 round plate and replaced by the lighting part, and peel off the white tapes to stick on the spot light...
Page 3
This is how it looks like after installation, and mind the direction of the wires Otherwise it may not long enough Put the spot light back to the position then install the green lighting plates as shown...
Page 4
For the other lighting part, do the same thing for the spot light as the previous steps Also mind the direction Remove the gold plates and assemble with the lighting parts...
Page 5
Restore the spot light, two wall lights and the candles stand...
Page 6
Now for the lighting green round bricks, install on the first pole, pull the wire to the ground then to the middle pole Then repeat the steps to the 3 pole and will look like this...
Page 7
For the remain lighting yellow round plate, install it at the table besides the pole...
Page 8
Connect the plugs to the USB cable and that’s it...
Need help?
Do you have a question about the FRIENDS Lego 21319 and is the answer not in the manual?
Questions and answers