Download Print this page
Glow Bricks HarryPotter 4 Privet Drive Lego 75968 Installation Manual

Glow Bricks HarryPotter 4 Privet Drive Lego 75968 Installation Manual

Advertisement

Quick Links

4 Privet Drive
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the HarryPotter 4 Privet Drive Lego 75968 and is the answer not in the manual?

Questions and answers

Summary of Contents for Glow Bricks HarryPotter 4 Privet Drive Lego 75968

  • Page 1 4 Privet Drive...
  • Page 2 Start by installing car lights First of all detach the two bricks and remove the clear yellow tiles...
  • Page 3 Install the tiles to lighting bricks, put them back to the head light position Then place the wire in between the white studs Restore the 1x6 blue plate and the slope, watch out don’t break the wire...
  • Page 4 Pull the remain lights to the back of the car, and detach the parts shown Replace the following lights to the rear lights position...
  • Page 5 Restore the parts removed from previous steps, move the lighting plate to the middle Then install then as shown...
  • Page 6 Before closing the top, connect with the battery case Or connect with the USB cable...
  • Page 7 Now it’s turn for the house Take the cone with shorter cable to replace the lighting on the front door...
  • Page 8 For the 1x4 grey lighting plate next to the cone, install it on top of the door The 1x4 tan lighting plate next to the grey plate install it to indoor area...
  • Page 9 Tap up the plate in red circle, place the wire in between the studs Install the 1x4 tan lighting plate in red circle area, then remove the picture, place the cable in between the studs then restore the picture...
  • Page 10 Then pull the remain two lighting plates to 2 floor and install them on ceiling For the other lighting cone, move it to the room under the stairs...
  • Page 11 Remove the shown parts, place the wire in between the studs and replace the lamp...