Related Manuals for Glow Bricks GHOSTBUSTERS ECTO-1 Lego 10274
Summary of Contents for Glow Bricks GHOSTBUSTERS ECTO-1 Lego 10274
- Page 2 First of all, remove the headlights and the clear round plates on frog lights For the red circle area, leave one round plate on each side Take the following lighting part ready...
- Page 3 Install the lighting parts, remove the tiles to put the wires in between the studs Restore the tiles, for the connector put it through the hole...
- Page 4 Remove the siren lights and take the following lighting part (the grey bottom one with 3 blue 2x2 round plates) Remove the parts from the original parts and move them to the light...
- Page 5 Install the lights on the top first, make sure the direction of connector is correct Take the slope away to pull the blue round plate to the side mirror position...
- Page 6 Take the following lighting part, remove the original part from the model Install the lights, pull the wire down to the same place as the previous part...
- Page 7 Restore the parts removed, the connectors are place inside the car Take this lighting parts to install inside the car...
- Page 8 Install the grey plate above the drive seat Then install the rest black plates at the back *If you feel difficult to install you may remove the top of the car...
- Page 9 Now it’s turn for the rear lights, take the rear bumper out, detach as shown Remove the clear red parts from the car and leave the 1x1 plates Combine the lighting parts with the grey parts, pass the lighting cones through the holes...
- Page 10 Restore the parts to the plate, split the bricks as shown Then put the wire in between the studs of the plate Put one side of the brick on and arrange the wire for other side...
- Page 11 Then restore the other brick Now remove the back door the install the black lighting plate...
- Page 12 Put the wire in between 2 joints for the door Then install the black plate...
- Page 13 Take the blue siren lights off, remove the parts to put on the lighting parts Install the siren light first, lift the white part in middle to hide the wire underneath...
- Page 14 For the connector, pull it inside the car through here Now collect 3 connectors to the back to connect with power...
- Page 15 Connect by battery case, place it as shown Connect by USB, pull it through the bottom...
- Page 16 For the connectors at front, the battery case can be place under the seat For the USB cable, can clip the wire by the slope...
Need help?
Do you have a question about the GHOSTBUSTERS ECTO-1 Lego 10274 and is the answer not in the manual?
Questions and answers