Solo Ii Ct: Consumption; Setting Up - Geo Solo II CT User Manual

Solo II CT: Consumption

Setting up

Please note: by choosing [CONSUMPTION]
mode, you will not be collecting data for
[MICRO-GEN] mode. If you choose to
switch modes you will lose all data you
have collected as the display will reset to
day one.
1. Plug the
the display. Your display will turn on
automatically when you plug it into
the mains supply.
Whenever the display is turned on, you
will see the [SET CLOCK] screen.
Use the and buttons on the front of
the display to adjust the time and date –
then press the centre button when you
have finished.
2. Open the transmitter and remove the
battery tab.
Solo II CT: Consumption
power supply
battery tab
For a single phase pack (one mains sensor):
3. At your electricity meter, clip the
sensor around the mains live cable.
Your mains live cable is usually
identified by the colour brown, red
or the letter "L". You should hear a
'click' to indicate the sensor has been
into tightly closed.
4. Insert the other end of the sensor cable
in to any of the sockets in the bottom
of the transmitter and ensure it is
fully inserted.
3
For a three phase pack (three mains sensors):
5. At your electricity meter, clip the
sensors around the mains live cables
(attach one sensor per cable). Locate
your mains live cables, these are
usually identified by the colour brown,
red or the letter "L". You should hear
a 'click' to indicate that the sensors
have been securely fastened.
6. Insert the other end of the cables
in to the sockets in the bottom of
the transmitter and ensure they are
fully inserted.
5
4
6
5