Bridge - Geo Solo II CT User Manual

Temperature sensor 1
(available separately)
For when you want two additional
temperature sensors.
The display will show [T1 SENSOR],
and will show [NONE] if it is using its
integrated sensor.
1. To pair an additional sensor, ensure
the display is showing [NONE] and
then press and hold the button on the
additional temperature sensor until its
LED flashes. The display will pair and
change to [CONN]
To unpair the additional sensor and use
the integrated sensor instead, press and
hold the centre button until the display
shows [NONE].
Temperature Sensor 2
(available separately)
The display will show [T2 SENSOR], and
will show [CONN] if a sensor is paired.
1. To unpair the additional sensor press
and hold the centre button until the
display shows [NONE]
To pair an additional sensor, ensure the
display is showing [NONE] and then press
and hold the button on the additional
temperature sensor until its LED flashes.
The display will pair and change to [CONN].
Solo II CT: Consumption

Bridge

(available separately as a Web Pack)
The Solo II can connect to the web using
the optional Web Pack (which includes a
bridge). To enter pairing mode press and
at the same time for a few seconds.
The display will show [BRIDGE CONN] if it is
already paired with the bridge (bridge must
be powered on).
If the bridge needs pairing the display will
show [BRIDGE NONE].
1. Unplug the bridge from the mains
2. Hold down the
the display together until you see
[PAIRMODE]
3. Use the button to toggle to [BRIDGE]
4. If the display shows [CONN], hold down
the middle button until the display
shows [NONE]
5. Hold down the pairing button on the
back of the bridge and at the same
time power on the bridge and keep
holding the button until the amber
light turns solid
The display should now read [CONN]
followed by a cloud symbol on the top left
hand corner.
and buttons on
pairing button
17