Table of Contents
Advertisement
Temperature set-point
The display can tell you if your home
is running warmer or cooler than your
ideal temperature. Use the and buttons
to set your ideal temperature and press the
centre button to confirm.
Advanced configuration
Press and hold the centre button for
three seconds to enter the configuration
mode. Using the
[ADVANCED] and then press the centre
button to confirm.
Next you need to tell the display about
your electricity meter and the rate at which
your electricity flows. You can read more
about this under the Electricity meter
section below.
You will be asked to set the following:
•
[CONSUMPTION] or [MICRO-GEN]
•
[CURRENCY]
•
[TEMPERATURE UNITS]
•
[CALIBRATION]
•
[DISPLAY OFF]
•
[DISPLAY ON]
•
[WEEK START]
8
and
buttons select
Mode and preferences
You can use the display to monitor your
energy use [CONSUMPTION] or generated
energy [MICRO-GEN]. The default is
[CONSUMPTION] mode.
Using the
and
[CONSUMPTION] and press the centre
button to confirm.
Currency
Using the and buttons select your currency
and press the centre button to confirm.
Temperature units
Select whether you want the temperature
to be shown in centigrade (°C) or
Fahrenheit (°F).
Using the
and
and press the centre button to confirm.
buttons select
buttons select °C or °F
Solo II CT: Consumption
Advertisement
Table of Contents
