Table of Contents
Advertisement
Pairing
The transmitter, display and bridge
are supplied pre-paired. If you need to
re-pair them or add new components to
your system this section tells you how to
do so.
To enter pairing mode press and at the
same time for a few seconds.
Transmitter [MAIN SENSOR]
If the transmitter (main sensor) is already
paired it will show [CONN] (connected). If
not, it will show [NONE].
To unpair the transmitter press and
hold the centre button until the display
shows [NONE].
To pair the transmitter press and hold the
button on the transmitter until the LED
flashes. The display is now paired and will
show [CONN].
16
Temperature sensors
The Solo II uses an integrated temperature
sensor. By default, this is represented as
temperature sensor 1 on the display. If you
choose to pair an additional temperature
sensor you should pair this to temperature
sensor 2 (currently empty). If you wish to
use two additional temperature sensors,
you'll need to overwrite temperature
sensor 1. To enter pairing mode press
and at the same time for a few seconds.
Step 1
Squeeze the two clips on each side and
slide the cover off.
Step 2
Remove the battery tab from the
temperature sensor.
Step 3
Press
the
pairing
temperature sensor.
battery tab
button
on
the
pairing button
Solo II CT: Consumption
Advertisement
Table of Contents
