Fisher & Paykel RS6121S Installation Manual page 43

Tools Adjusting the height of door the panel
Ensure the side brackets are loosely screwed when adjusting the height of the
door panel. Do not adjust the door panel height when the side brackets are
screwed tight. This can generate friction which causes the hanging brackets to
bend.
Cross-head
screwdriver
M4 hex key (1)
Lower
13mm spanner (1x)
Adjust the depth of door panel
Illustrations may differ from your purchased appliance.
DOOR PANEL INSTALLATION
Turn the adjustment screw to raise
or lower the height of the door panel
relative to the door.
Continue adjustment until gap with
cabinetry is more than 3mm.
Do not adjust the adjustment screw
z
higher than 1/4" (6.5mm) from its
fully down position.
Raise
Loosen side screws on the side
brackets, and slide door panel
forward/backward.
Re-tighten once satisfied.
Re-adjusing the door panel
To adjust door panel further, remove the
door panel then loosen the fixing screws
of the hanging bracket and move the
bracket sideways to suit.
To adjust door panel further, remove the
door panel then loosen the fixing screws
of the hanging bracket and move the
bracket sideways to suit.
z
Once satisfied with door panel position,
fully tighten M8 washer and nut to
adjustment screw.
43