Fisher & Paykel RS6121S Installation Manual page 60

Move the sensor housing
Unclip the hall sensor
1
from the housing.
Unhook the interceptor
board harness from
2
sensor housing so
harness is loose.
Remove the #8x16 screws
3
(2x) from the sensor
housing.
60
CHANGE THE DOOR HINGES (OPTIONAL)
Move the sensor housing
to align the opposite hall
4
sensor clip with the centre
of the cabinet.
Reinstall the sensor housing
using #8x16 screws (2x)
5
into the pre-drilled holes in
the cabinet top panel.
Clip the hall sensor into
the sensor housing in
6
the pocket closest to the
F
centreline of the cabinet.
Press the harness from
7
the interceptor board into
the forks on the sensor
housing.