Advertisement
Quick Links
We greatly appreciate your purchase of the unit
Be sure to take maximum advantage of all the unit has to offer, read these
instructions carefully and use the set properly. Be sure to keep this manual
for future reference, should any questions or problems arise.
SE600.1DF
SE1000.1DF
SE2000.1DF
SE3000.1DF
Advertisement
Related Manuals for Bass Habit SE600.1DF
Summary of Contents for Bass Habit SE600.1DF
- Page 1 SE600.1DF SE1000.1DF SE2000.1DF SE3000.1DF We greatly appreciate your purchase of the unit Be sure to take maximum advantage of all the unit has to offer, read these instructions carefully and use the set properly. Be sure to keep this manual...
-
Page 2: Pre-Installation
BASS HABIT accepts no liability for hearing loss, bodily injury or property damage resulting from the use/misuse of this product. To get the very best performance from your BASS HABIT SPL Elite amplifier, we recommend that installation be intrusted to a qualified installer. Although these instructions explain how to install BASS HABIT Play amplifiers in general, they do not show specific installation methods... - Page 3 POWER/SPEAKER CONNECTION (FIG 1 & FIG 2) The Bass Habit SPL Elite amplifiers are capable of delivering extremely high power levels and require a heavy-duty and reliable connection to the vehicle’s electrical system. To get the very best performance out of your Bass Habit SPL Elite amplifier, carefully follow the instructions...
- Page 4 SE600.1DF / SE1000.1DF / SE2000.1DF / SE3000.1DF SE600.1DF / SE1000.1DF / SE2000.1DF / SE3000.1DF SE1000.1DF SE2000.1DF SE600.1DF SE3000.1DF...
- Page 5 FRONT PANEL (FIG 3) Bass Habit SPL Elite are Class D amplifiers and can be used for speakers and subwoofers in the range between 15Hz - 20KHz. LOW/HIGH and LOW+HIGH crossover mode can be used simultaneously. While listening to music, adjust the gain/crossover/subsonic/bass boost for the least per- ceived distortion from the speakers, allowing them to reproduce as much bass as possible.
- Page 6 SE600.1DF / SE1000.1DF / SE2000.1DF / SE3000.1DF Connect RCA signal cable from audio source (input) or RCA signal input/output connect another mono amplifier (output). RCA signal input Connect RCA signal cable from audio source High pass filter (HPF) Adjust the High pass filter’s crossover point. 15Hz - 80Hz for 1000.1DF, 2000.1DF &...
-
Page 7: Specifications
SPECIFICATIONS: SE600.1DF SE1000.1DF • Number of channels: 1CH • Number of channels: 1CH • Power output (RMS) @ 1 ohm: 1x600W • Power output (RMS) @ 1 ohm: 1x1000W • Power output (RMS) @ 2 ohm: 1x450W • Power output (RMS) @ 2 ohm: 1x750W •... -
Page 8: Troubleshooting
TROUBLESHOOTING: Symptom Check / Control No audio. (Power LED not active) Measure voltage at +12V and REM terminals. Check GND connections. Distorted audio Check GAIN control, so it is properly set. Check source unit or amplifier, if defective it can cause distortion. Music lacks bass and attack Check speaker connections for proper polarity.