Advertisement
FRONT PANEL (FIG 3)
Bass Habit SPL Elite are Class D amplifiers and can be used for speakers and subwoofers in
the range between 15Hz - 20KHz. LOW/HIGH and LOW+HIGH crossover mode can be used
simultaneously.
While listening to music, adjust the gain/crossover/subsonic/bass boost for the least per-
ceived distortion from the speakers, allowing them to reproduce as much bass as possible.
Line Input
Connect the line outputs from your source unit and connect them to the Line L and R inputs.
Line Output
Bass Habit SPL Elite 1-channel amplifiers are equipped with full-range output that can be used
to connect additional amplifiers.
Input level control (GAIN):
GAIN control is a seamless adjustable between 0,2V- 6 V.
Tips for adjusting the GAIN control correctly:
- Initially turn the GAIN control to minimum (counter clockwise).
- On the source unit, increase the volume control to the 3/4 of maximum volume.
- Slowly increase the GAIN control until you hear slight distortion in the speaker/speakers.
- Then reduce the GAIN slightly until distortion is no longer heard.
Bass Boost control (BASS BOOST):
Bass Boost is seamless adjustable between 0-12 db (35Hz - 70 Hz)
Please use the BASS BOOST knob with care, excessive use can damage you system!
LPF Crossover (LPF):
The low pass filter is seamless adjustable between 80Hz - 20KHz. When using a subwoofer,
set the frequency cut point at 80Hz and adjust to your own preferences.
HPF Crossover (HPF):
The high pass filter is seamless adjustable between 15Hz–80Hz for the models SE1000.1/
SE2000.1/SE3000.1 and 15Hz - 1KHz for the model SE600.1. The HPF can be used for re-
moving the deepest bass notes from the subwoofer, get a tighter and more rhythmical
sound. For a normal setup the HPF should be adjusted to the "15 Hz" setting. If using full
range speakers, set the crossover knob to HIGH (high pass), Adjust the crossover frequency
to limit bass and lower distortion.
Remote Level Control (REMOTE)
Included with the Bass Habit SPL Elite 1-channel amplifiers is a subwoofer remote volume
control. This allows you to adjust the level from your listening position. Install the controller
at a convenient position close to the driver seat, and connect it to the REMOTE jack on the
amplifier.
Advertisement
