Advertisement
POWER/SPEAKER CONNECTION (FIG 1 & FIG 2)
The Bass Habit SPL Elite amplifiers are capable of delivering extremely high power levels and
require a heavy-duty and reliable connection to the vehicle's electrical system. To get the very
best performance out of your Bass Habit SPL Elite amplifier, carefully follow the instructions
below:
Ground Connection (GND):
Connect the amplifiers Ground (GND) terminal to a solid point on the vehicles metal chassis,
as close to the amplifiers as possible.
Scrape away any paint from this location; use a star-type lock washer to secure the connection.
Ground wire minimum size:
SE600.1DF min. 4 awg/ 20mm2
SE1000.1DF min. 4 awg/ 20mm2
SE2000.1DF min. 2 awg/ 35mm2
SE3000.1DF min. 0 awg/ 50mm2
Power Connection (+12V):
Connect a wire directly to the vehicles positive battery terminal, and install an appropriate fuse
and holder within 30cm/12" from the battery terminal.
Keep the fuse uninstalled at the time for routing and connecting the power wire.
Be sure to use grommets whenever routing wires through the firewall or other metal parts.
When routing/connecting is done, installation of the fuse into fuse holder can be finalised.
+12V wire minimum size:
SE600.1DF min. 4 awg/ 20mm2
SE1000.1DF min. 4 awg/ 20mm2
SE2000.1DF min. 2 awg/ 35mm2
SE3000.1DF min. 0 awg/ 50mm2
Remote Connection (REM):
Connect the amplifiers Remote (REM) terminal to the source unit Remote turn on lead using a
minimum of 0.75mm2/18 gauge wire.
If your source unit does not have a turn on connection, connect the amplifier (REM) terminal
through a power switch button which can provide a +12V signal.
Speaker connections (SPEAKER OUTPUT):
Speaker connections should be made using a minimum of 1,25 mm2/16 gauge wire.
Minimum total allowed impedance load is 1 ohm.
Advertisement
