Bass Habit PP70.2 Owner's Manual
  1. Manuals
  2. Brands
  3. Bass Habit Manuals
  4. Amplifier
  5. PP70.2
  6. Owner's manual

Bass Habit PP70.2 Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
PP70.2

Advertisement

Table of Contents
loading

Related Manuals for Bass Habit PP70.2

Summary of Contents for Bass Habit PP70.2

  • Page 1 PP70.2...

  • Page 2: Safety Instructions

    Closely follow the advices, recommendations and safety precautions. Thank you for choosing Bass Habit! We hope you enjoy listening to your product as much as we have enjoyed creating it. SAFETY INSTRUCTIONS Do not expose this product to damp or moisture - doing so may result in fire, shock or...

  • Page 3: Installation

    INSTALLATION Turn off the audio system and other electronic devices before you start. Disconnect the negative (-) lead from your vehicle’s battery. Choose a mounting location in an area where the amplifier will not be damaged, and where the amplifier is not covered up. Mount the amplifier so that it remains dry - never mount an amplifier outside the vehicle or in the engine compartment.
  • Page 4 POWER CONNECTIONS (FIG 1) To get the very best performance out of your Bass Habit amplifier, carefully follow the instructions below. Contact your local Bass Habit dealer to ensure that you have the correct size wiring kit and fuse. Power Connection (+12V): Connect the 12V power supply cable after all other leads have been connected and secured.
  • Page 5 SPEAKER CONNECTIONS (FIG 2, FIG 3) Speaker connections should be made using a minimum of 1,25 mm2/16-gauge wire. FIG 2: 2-CHANNEL STEREO SPEAKER SYSTEM 2-8 Ohm 2-8 Ohm FIG 3: 1-CHANNEL STEREO BRIDGED min. 4 Ohm...
  • Page 6 SIGNAL CABLE CONNECTION (FIG 4) Use high quality RCA jack cables to make sure you get the full audio experience. FIG 4: SIGNAL CABLE CONNECTION...
  • Page 7 SETTINGS Bass Habit PP70.2 is a Class A/B amplifier and can be used for all type of speakers in the range between 20Hz-20kHz. While listening to music, adjust the gain/crossovers/bass boost for the least perceived distortion from the speakers. CROSSOVERS: The Bass Habit Play PP70.2 amplifier is a full range class A/B amplifier.
  • Page 8 FIG 5: FUNCTIONS INPUT RCA signal input GAIN Gain control rear, input signal adjustment 0.2V-6V BASS BOOST 0/6/12dB bass level adjustment at 45Hz Low pass filter 50-500Hz (12dB/Oct) CROSSOVER Filter mode setting LPF, FLAT, HPF High pass filter 50Hz-3KHz (12dB/Oct) POWER Power indicator PROTECT...

  • Page 9: Specifications

    SPECIFICATIONS Model No. PP70.2 RMS @2 Ohm 2x100W RMS @4 Ohm 2x70W RMS bridged @4 Ohm 1x180W Low pass filter 50Hz-500Hz High pass filter 50Hz-3kHz Bass Boost 12/6/0dB (45Hz) Frequency response 20Hz-20kHz >85dB Input sensitivity 0.2V-6V <0.05% Operation Voltage 9-16V...

  • Page 10: Troubleshooting

    TROUBLESHOOTING: Symptom Check / Control No audio. (Power LED not active) Measure voltage at +12V and REM terminals. Check GND connections. Distorted audio Check GAIN control, so it is properly set. Check source unit or amplifier, if defective it can cause distortion. Music lacks bass and attack Check speaker connections for proper polarity.

  • Page 11: International Warranty

    WARRANTY All Bass Habit products carry a full warranty depending on the conditions in the country where it is sold. The Warranty is valid from the date of the original receipt as proof of purchase. The warranty does NOT cover: •...

Table of Contents