Table of Contents
Advertisement
1.3 BACKDRIVABILITY WARNING
Axes G and D (see diagram below) use a software limits to ensure they do not rotate beyond their described Range of Motion. When power is off, this software limit is
inactive allowing the joint to be rotated past its limit.
When the arm is powered on, it does not know it has been rotated past its limit and will continue as normal. This can cause damage to the joint.
Page 4 of 37
Blueprint Lab Confidential Proprietary Information not to be reproduced or made available to third parties without prior consent from Blueprint Lab and not to be used in any unauthorised way. © Blueprint Lab Pty
Ltd 2021
Advertisement
Table of Contents
