Table of Contents
Advertisement
5) Ensure sheath is slid over pushrod. Rotate
pushrod if needed.
7) Ensure the included power and
communications cables are securely
connected to the Breakout Board (BoB).
1) Connect the power supply to the BoB. Plug
the other end into a wall socket. Turn on.
This completes the mechanical setup procedure.
Blueprint Lab Confidential Proprietary Information not to be reproduced or made available to third parties without prior consent from
Blueprint Lab and not to be used in any unauthorised way. © Blueprint Lab Pty Ltd 2021
6) Screw the
screw
with the 3/16 In. Allen key to secure.
8) Plug the power and communications cables
into the arm.
2) Use an ethernet cable to connect the BoB
to your computer.
Page 27 of 37
collar
to tighten. Fasten the
Advertisement
Table of Contents
