3D LabPrint WACO YMF-5 User Manual page 16

5.2.2 Fuselage tail - elevator pushrods and servos
Glue vertical stabiliser 1 & 2 to the fuselage. Glue all parts of rudder together. Glue L1 and L2
parts of the elevator. The profile is symmetric, so the left and right sides are identical. Glue
elevator arm together and smooth the surface with sand paper (you can use drill). Glue the
horizontal stabilizers perfectly perpendicular to the fuselage. Make a Z bend on the elevator
pushrod wire. Repeat it for rudder pushrod wire. Mount the elevator assembly to the
stabilizer using the 1,2 - 1,5 mm carbon rod or steel wire. Glue elevator lock to the fuselage.
Mount the rudder assembly to the vertical stabilizer using the 1,2 - 1,5 mm carbon rod or steel
wire. Elevator and rudder should move freely controlled by the pushrod and servo. Check the
functionality of the elevator and rudder assembly.
you will need: CA Glue medium viscosity
1 - 1.2 mm steel wire for elevator and rudder pushrod
1,2 - 1,5 mm carbon or steel wire for elevator and rudder hinge
Snap knife
See video guide Tail Assebly
completed
stabiliser & elevator
... print your plane | www.3DLabPrint.com
vertical stabiliser 2
6g/0.21oz
vertical stabiliser 1
11g/0.39oz
+ activator
elevator lock
2g/0.07oz
elevator arm
5g/0.18oz
horizontal stabiliser L1
22g/0.78oz
16
page
rudder 5
2g/0.07oz
rudder 4
9g/0.32oz
rudder 3
15g/0.53oz
rudder 2
5g/0.18oz
rudder 1
7g/0.25oz
elevator L1
19g/0.67oz
elevator L2
11g/0.39oz