Setting Delay Start - Fisher & Paykel DW60U2I1 User Manual

This feature can delay the start of a wash programme by 1 to 12 hours.
1 Load the dishes, add detergent and close the door.
2 Open the door to turn the dishwasher on.
3 Check that the display shows the wash programme you require. If not, see instructions
for 'Changing the wash programme'.
4 Touch and hold
The delay start indicator
z
delay time (hours).
5 Touch again to increase the number of hours you wish to delay the wash by
(1hr – 12hr in hour steps).
Note: Scrolling past 12 hours will exit delay start.
6 Press and hold start button to start delay. The display will countdown in hours. The
wash programme will automatically start when the delay time is over.
The Delay start indicator will be on when Delay start begins its countdown.
z
If the door is open when the countdown is finished, the dishwasher will beep and the
z
display will flash. After 7 seconds the dishwasher will turn off.
To cancel Delay start, touch the start button until the delay hour is 12h, then press start
button again to cancel delay.

SETTING DELAY START

touch and hold
will light up and the display will show the
5