Fault Codes - Fisher & Paykel DW60U2I1 User Manual

If the dishwasher malfunctions, it will display a fault code and beep. Check the following
table below to see if you can correct the fault yourself.
FAULT
CODES AND
DESCRIPTIONS
A20
Drain fault
A10
No water

FAULT CODES

POSSIBLE CAUSES
Drain hose is
crimped or bent.
The waste water is
not draining out.
The turbidity
sensor is dirty and
requires cleaning.
Water tap not
turned on.
Insufficient water
supply pressure.
Water inlet hose is
crimped or bent, so
no or not enough
water gets to
the dishwasher.
Drain hose is not
connected correctly.
WHAT TO DO
Check the drain hose and straighten if needed.
Ensure that the drain hose is connected in
accordance with the installation instructions.
Gently clean the turbidity sensor with a soft
brush (ie toothbrush) to remove any buildup.
Turbidity
sensor
Ensure the water is connected and turned on.
Touch to restart the dishwasher.
Check household water pressure.
Check the water inlet hose and
straighten if needed. Touch
the dishwasher.
Ensure that the drain hose is connected in
accordance with the installation instructions.
to restart
23