Icom IC-F11BR Instruction Manual page 26

4
SET MODE
D D SETTING THE CTCSS TONE FREQUENCY (continued)
• CTCSS confirmation beep
Push [PTT]
no
1 (Once)
2 (Twice)
3 (Third)
4 (Fourth)
G; Single beep
D D FREQUENCY FIND
This transceiver can detect the operating frequency by scanning all
pre-programmed channels. Scan pauses when receiving the sig-
nal. You can assign that operating channel to your transceiver.
This function very useful when you are going to communicate with
unknown channel number stations.
You can also find which CTCSS tone number is being used by them
with the 'CTCSS FIND' function. (Next page)
q While pushing and holding [MONI], [W/N], turn [OFF/VOL] to
power ON.
w Select the desired CH 1 or 2 that you want to assign the fre-
quency.
e Push and hold [W/N] until a beep (Pi) is emitted.
• '
FREQUENCY FIND' start to scan the signal.
r 'FREQUENCY FIND' stops when the signal is detected.
t Push [W/N] to determine the frequency channel number.
y Turn the power OFF, and then ON again.
Note: CTCSS tone setting turns to No. 0 (OFF) automatically after
turn the power ON again.
19
Confirmation beep
G
G
GG
GGG
GGGG
; Long beep
Confirmation beep
Push [PTT]
GGGGG
5 (Fifth)
6 (Sixth)
7 (Seventh)
8 (eighth)
9 (ninth)
G
GG
GGG
GGGG